- Foam squares or circles do a mighty good job of popping stuff off the page--but they can be expensive and the plastic tabs you have to peel off to reveal the adhesive can be a pain.
- Foam tapes can be pricey as well, though I do prefer these over all 3D adhesives on the market because you can cut the length you'd like.
- 3D glue dots are pretty snotty--if you smoosh your item too hard onto the page, the item can become dome shaped instead of popped because the entire dot is adhesive, not just to top and bottom.
- Pockets made from paper alone don't allow for many items to be stuck inside. Also, depending on the adhesive you use, the insert may get stuck on the adhesive on the side of the pocket when sliding it in and out.
Cut 1/2" thick strips of chipboard from a scrap-you'll use these to line the edges of the pocket. You need two strips as tall as the pocket and one strip as wide as the pocket. Glue the bottom strip to the bottom inside edge of the pocket. Glue the other two strips ot the sides of the pocket, trimming any chipboard that hangs out over the top. Adhere the strips to the page--this forms the pocket. You put no adhesive on the top. There is enough room in this pockets for severla pictures and inserts pull in and out nicely.
Adhere a scrap of chipboard to the back of the item you wish to "pop". Layer more chipboard scraps to get a higher effect. Adhere to the page.
Have fun "popping"!